We have been
committed to the professional product development, production and
perfect service.
Being isolated. -
LRFM - cold wind Ⅱ new electric isolation series products
LRFM - cold wind Ⅱ new electric isolation series products are in our
current LRFM - Ⅱ cold wind, pneumatic draft, based on the part of the
plant, a new generation of renewal design cold wind throttle.in type.
This series of products with pneumatic draft all advantages:
1 this type eccentric principle, has the function of automatic. Being
flexible motion, and no acerbity.
2 nearly open positions display control, also can install far position
indicator agency, But some adjustment after opening size, also can be
interlock, Through the computer on remote control, also can be manually
near.
3 sealing material factory made by special formula, 450 ° circumstances,
with no wear eccentric wheel lock principle, therefore, no leakage is
closed, etc.
4 this series can be according to the environment, being horizontal
installation, perpendicular installation, 45 degrees of inclined
installation, vertical Ann to satisfy the site installation
requirements.
The main advantage
Being closed servo drive, and with the lock servo is divided into two
parts, and complete with eccentric clamping door plank, around the
sealing filler, completely close door block fluid. Servo drive and lock
servo mechanism can be finished in a short time, and closing and safe
and convenient operation. Draft or close by the ZB servo electrical
devices, the device type six points.
1, motor: the YDF type valves with three-phase asynchronous motor, the
motor for short-term work, working hours are not more than nominal for
10 minutes.
2 and reducer gear pair are: the composition, motor and worm gear
transmission of power through to the output shaft.
3 and control mechanisms: the torque control agencies, travel agencies
and the position control instructions mechanism.
4 and manual ~ electric switching mechanism: the agency for
semi-automatic switch. By electric manual to the handle to the manual
direction of artificial, until the middle with handwheel from middle
clutch engagement, namely into manual. When the manual for automatic
switch into power.
5 and the handwheel department set by the handwheel and manual axial,
composed, when used for manual adjustment. When malfunction, cut off
power supply, and unscrew the embossing nuts, worm and worm direction
with wrench according to regulations, make party tenon valve slightly
open before using the handwheel.
6 and lock using qq servo electrical devices, the device type for 90
degrees quarter-turn device drivers.
7 and prevent leakage of gas seal can pay by using compressed air, also
can use a fan of cold air.
Eight, the product using the principle of heat and learn point, the
reasonable use of carbon steel, alloy steel, stainless steel structure,
and the full use of advantages, my company treatment can ensure the
sluice gate structure on the whole, the door of 450 environment and hot
huge disparities circumstances not deformation.
